[PATCH linux 6.18 1/2] dt-bindings: hwmon: pmbus: ti,lm25066: add current limit properties

Add a 'ti,current-range' string property to configure the device's Current
Limit (CL) behavior to "high" or "low" via the register, overriding the
physical CL pin setting.

This configuration is supported on LM25066, LM5064, LM5066, and LM5066i.
LM25056 is excluded because it does not support configuring the current
limit via the DEVICE_SETUP register (bit 2 of DEVICE_SETUP is reserved).

The values "low" and "high" map to the respective low/high threshold
voltages of the chips:
- LM25066: low = 25 mV, high = 46 mV
- LM5064, LM5066, LM5066i: low = 26 mV, high = 50 mV

Reviewed-by: Conor Dooley <[email protected]>
Signed-off-by: Potin Lai <[email protected]>
---
 .../bindings/hwmon/pmbus/ti,lm25066.yaml      | 20 +++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/Documentation/devicetree/bindings/hwmon/pmbus/ti,lm25066.yaml b/Documentation/devicetree/bindings/hwmon/pmbus/ti,lm25066.yaml
index a20f140dc79a..fe42daabaaa8 100644
--- a/Documentation/devicetree/bindings/hwmon/pmbus/ti,lm25066.yaml
+++ b/Documentation/devicetree/bindings/hwmon/pmbus/ti,lm25066.yaml
@@ -46,12 +46,32 @@ properties:
 
     additionalProperties: false
 
+  ti,current-range:
+    description: |
+      Configure the current limit setting. When present, this property
+      overrides the hardware setting of the physical CL pin by configuring
+      the DEVICE_SETUP register.
+      - "low": maps to 25 mV (LM25066) or 26 mV (LM5064, LM5066, LM5066i)
+      - "high": maps to 46 mV (LM25066) or 50 mV (LM5064, LM5066, LM5066i)
+    $ref: /schemas/types.yaml#/definitions/string
+    enum:
+      - low
+      - high
+
 required:
   - compatible
   - reg
 
 allOf:
   - $ref: /schemas/hwmon/hwmon-common.yaml#
+  - if:
+      properties:
+        compatible:
+          contains:
+            const: ti,lm25056
+    then:
+      properties:
+        ti,current-range: false
 
 unevaluatedProperties: false
 
-- 
2.52.0