Re: [PATCH 1/5] arm64: dts: freescale: Import optee node from u-boot device trees
Frank Li <[email protected]> Fri, 10 Jul 2026 16:09:12 -0500
| Newsgroups | org.ozlabs.lists.openbmc,dev.linux.lists.imx,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <alFfeOFz2UA7hAbK@SMW015318> |
On Fri, Jul 10, 2026 at 05:31:34PM +0200, Mathieu Dubois-Briand wrote: > [You don't often get email from [email protected]. Learn why this is important at https://aka.ms/LearnAboutSenderIdentification ] > > U-Boot is importing kernel device trees for these platforms, but adding > a firmware node to enable communication with OP-TEE. Importing > changes here will allow to remove these additions in U-Boot. > > Signed-off-by: Mathieu Dubois-Briand <[email protected]> > --- > arch/arm64/boot/dts/freescale/imx8mm.dtsi | 7 +++++++ > arch/arm64/boot/dts/freescale/imx8mn.dtsi | 7 +++++++ > arch/arm64/boot/dts/freescale/imx8mp.dtsi | 7 +++++++ Please split soc dts change to new patch. Frank > arch/arm64/boot/dts/freescale/imx91-11x11-evk.dts | 7 +++++++ > arch/arm64/boot/dts/freescale/imx91-11x11-frdm.dts | 7 +++++++ > arch/arm64/boot/dts/freescale/imx91-phyboard-segin.dts | 7 +++++++ > arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts | 7 +++++++ > arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts | 7 +++++++ > arch/arm64/boot/dts/freescale/imx93-kontron-bl-osm-s.dts | 7 +++++++ > arch/arm64/boot/dts/freescale/imx93-phyboard-segin.dts | 7 +++++++ > arch/arm64/boot/dts/freescale/imx93-var-som-symphony.dts | 7 +++++++ > 11 files changed, 77 insertions(+) > > diff --git a/arch/arm64/boot/dts/freescale/imx8mm.dtsi b/arch/arm64/boot/dts/freescale/imx8mm.dtsi > index 5cf2998d396d..4a55464e8a6f 100644 > --- a/arch/arm64/boot/dts/freescale/imx8mm.dtsi > +++ b/arch/arm64/boot/dts/freescale/imx8mm.dtsi > @@ -233,6 +233,13 @@ timer { > arm,no-tick-in-suspend; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > thermal_zones: thermal-zones { > cpu-thermal { > polling-delay-passive = <250>; > diff --git a/arch/arm64/boot/dts/freescale/imx8mn.dtsi b/arch/arm64/boot/dts/freescale/imx8mn.dtsi > index 79b169b07c4f..c3b4560ec9b4 100644 > --- a/arch/arm64/boot/dts/freescale/imx8mn.dtsi > +++ b/arch/arm64/boot/dts/freescale/imx8mn.dtsi > @@ -265,6 +265,13 @@ timer { > arm,no-tick-in-suspend; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > soc: soc@0 { > compatible = "fsl,imx8mn-soc", "simple-bus"; > #address-cells = <1>; > diff --git a/arch/arm64/boot/dts/freescale/imx8mp.dtsi b/arch/arm64/boot/dts/freescale/imx8mp.dtsi > index 5ce2825182fd..285b98384255 100644 > --- a/arch/arm64/boot/dts/freescale/imx8mp.dtsi > +++ b/arch/arm64/boot/dts/freescale/imx8mp.dtsi > @@ -404,6 +404,13 @@ timer { > arm,no-tick-in-suspend; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > soc: soc@0 { > compatible = "fsl,imx8mp-soc", "simple-bus"; > #address-cells = <1>; > diff --git a/arch/arm64/boot/dts/freescale/imx91-11x11-evk.dts b/arch/arm64/boot/dts/freescale/imx91-11x11-evk.dts > index 5716febb5a50..c7050bafacae 100644 > --- a/arch/arm64/boot/dts/freescale/imx91-11x11-evk.dts > +++ b/arch/arm64/boot/dts/freescale/imx91-11x11-evk.dts > @@ -110,6 +110,13 @@ linux,cma { > }; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > sound-wm8962 { > compatible = "fsl,imx-audio-wm8962"; > model = "wm8962-audio"; > diff --git a/arch/arm64/boot/dts/freescale/imx91-11x11-frdm.dts b/arch/arm64/boot/dts/freescale/imx91-11x11-frdm.dts > index c25561574d3f..c0156921414f 100644 > --- a/arch/arm64/boot/dts/freescale/imx91-11x11-frdm.dts > +++ b/arch/arm64/boot/dts/freescale/imx91-11x11-frdm.dts > @@ -152,6 +152,13 @@ linux,cma { > }; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > soc@0 { > bootph-all; > bootph-pre-ram; > diff --git a/arch/arm64/boot/dts/freescale/imx91-phyboard-segin.dts b/arch/arm64/boot/dts/freescale/imx91-phyboard-segin.dts > index 022e9c6841ef..62b6eff013f1 100644 > --- a/arch/arm64/boot/dts/freescale/imx91-phyboard-segin.dts > +++ b/arch/arm64/boot/dts/freescale/imx91-phyboard-segin.dts > @@ -35,6 +35,13 @@ chosen { > stdout-path = &lpuart1; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > flexcan1_tc: can-phy0 { > /* TI SN65HVD234D CAN-CC 1MBit/s */ > compatible = "ti,tcan1043"; > diff --git a/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts b/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts > index c6db9c85f2ac..0bea169d7029 100644 > --- a/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts > +++ b/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts > @@ -42,6 +42,13 @@ reg_usdhc3_vmmc: regulator-usdhc3 { > enable-active-high; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > usdhc3_pwrseq: usdhc3_pwrseq { > compatible = "mmc-pwrseq-simple"; > reset-gpios = <&pcal6524 12 GPIO_ACTIVE_LOW>; > diff --git a/arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts b/arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts > index 01c11c517986..6b99c0594125 100644 > --- a/arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts > +++ b/arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts > @@ -147,6 +147,13 @@ reg_usdhc3_vmmc: regulator-usdhc3 { > enable-active-high; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > sound-bt-sco { > compatible = "simple-audio-card"; > simple-audio-card,name = "bt-sco-audio"; > diff --git a/arch/arm64/boot/dts/freescale/imx93-kontron-bl-osm-s.dts b/arch/arm64/boot/dts/freescale/imx93-kontron-bl-osm-s.dts > index 4620c070f4d7..b8fa0cda33b2 100644 > --- a/arch/arm64/boot/dts/freescale/imx93-kontron-bl-osm-s.dts > +++ b/arch/arm64/boot/dts/freescale/imx93-kontron-bl-osm-s.dts > @@ -62,6 +62,13 @@ reg_vcc_panel: regulator-vcc-panel { > regulator-min-microvolt = <3300000>; > regulator-name = "VCC_PANEL"; > }; > + > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > }; > > &eqos { /* Second ethernet (OSM-S ETH_B) */ > diff --git a/arch/arm64/boot/dts/freescale/imx93-phyboard-segin.dts b/arch/arm64/boot/dts/freescale/imx93-phyboard-segin.dts > index d929aa9ff255..e96b8437f922 100644 > --- a/arch/arm64/boot/dts/freescale/imx93-phyboard-segin.dts > +++ b/arch/arm64/boot/dts/freescale/imx93-phyboard-segin.dts > @@ -36,6 +36,13 @@ chosen { > stdout-path = &lpuart1; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > flexcan1_tc: can-phy0 { > compatible = "ti,tcan1043"; > #phy-cells = <0>; > diff --git a/arch/arm64/boot/dts/freescale/imx93-var-som-symphony.dts b/arch/arm64/boot/dts/freescale/imx93-var-som-symphony.dts > index 409c7e74ffe3..20eaabc23b49 100644 > --- a/arch/arm64/boot/dts/freescale/imx93-var-som-symphony.dts > +++ b/arch/arm64/boot/dts/freescale/imx93-var-som-symphony.dts > @@ -125,6 +125,13 @@ ele_reserved: ele-reserved@87de0000 { > }; > }; > > + firmware { > + optee: optee { > + compatible = "linaro,optee-tz"; > + method = "smc"; > + }; > + }; > + > gpio-keys { > compatible = "gpio-keys"; > > > -- > 2.47.3 > >