Re: [PATCH 3/4] clk: rockchip: rk3576: Always init clocks in SPL build

Hi Alexey,

On 8/5/2026 9:21 AM, Alexey Charkov wrote:
> Hi Jonas,
> 
> Thanks a lot for your work on this!

Thanks for testing!

I think using the 'probe after bind' flag ended up being the most
logical way to ensure the clocks are initialized early in SPL.

> 
> On Tue, Aug 4, 2026 at 4:26 AM Jonas Karlman <[email protected]> wrote:
>>
>> The ore PLLs are only initialized in SPL on RK3576.
> 
> /s/ore/core/ ?

Hehe, correct, my bad, that is what happens when one tries to send out
patches in the middle of the night ;-)

Will send a v2 unless Quentin wants to fixup when applying.

Regards,
Jonas

> 
>> Ensure clock driver is always probed after bind for SPL builds to
>> initialize core PLLs and clocks in SPL phase on RK3576.
>>
>> Signed-off-by: Jonas Karlman <[email protected]>
>> ---
>>  drivers/clk/rockchip/clk_rk3576.c | 4 ++++
>>  1 file changed, 4 insertions(+)
> 
> Tested it with my 41MB Falcon Linux payload on a Flipper One (RK3576),
> and it gives a very noticeable improvement in loading speed: time from
> start of BL33 to initramfs goes down from ~20s to ~3s, which is quite
> welcome :)
> 
> Tested-by: Alexey Charkov <[email protected]>
> 
> Best regards,
> Alexey