[PATCH v6 01/87] usb: host: re-import xhci-ext-caps.h from kernel v6.16

Anders Roxell <[email protected]>
Newsgroups org.u-boot-project.lists.u-boot
Message-ID <[email protected]>
From: Jerome Forissier <[email protected]>

Import drivers/usb/host/xhci-ext-caps.h from Linux v6.16. The file
is needed by the updated DWC3 code.

Signed-off-by: Jerome Forissier <[email protected]>
Signed-off-by: Jens Wiklander <[email protected]>
Signed-off-by: Anders Roxell <[email protected]>
Reviewed-by: Mattijs Korpershoek <[email protected]>
---
 drivers/usb/host/xhci-ext-caps.h | 158 +++++++++++++++++++++++++++++++
 1 file changed, 158 insertions(+)
 create mode 100644 drivers/usb/host/xhci-ext-caps.h

diff --git a/drivers/usb/host/xhci-ext-caps.h b/drivers/usb/host/xhci-ext-caps.h
new file mode 100644
index 000000000000..c93bcf4f4f7d
--- /dev/null
+++ b/drivers/usb/host/xhci-ext-caps.h
@@ -0,0 +1,158 @@
+/* SPDX-License-Identifier: GPL-2.0 */
+/* Imported from Linux v6.16 */
+/*
+ * xHCI host controller driver
+ *
+ * Copyright (C) 2008 Intel Corp.
+ *
+ * Author: Sarah Sharp
+ * Some code borrowed from the Linux EHCI driver.
+ */
+
+/* HC should halt within 16 ms, but use 32 ms as some hosts take longer */
+#define XHCI_MAX_HALT_USEC	(32 * 1000)
+/* HC not running - set to 1 when run/stop bit is cleared. */
+#define XHCI_STS_HALT		(1<<0)
+
+/* HCCPARAMS offset from PCI base address */
+#define XHCI_HCC_PARAMS_OFFSET	0x10
+/* HCCPARAMS contains the first extended capability pointer */
+#define XHCI_HCC_EXT_CAPS(p)	(((p)>>16)&0xffff)
+
+/* Command and Status registers offset from the Operational Registers address */
+#define XHCI_CMD_OFFSET		0x00
+#define XHCI_STS_OFFSET		0x04
+
+#define XHCI_MAX_EXT_CAPS		50
+
+/* Capability Register */
+/* bits 7:0 - how long is the Capabilities register */
+#define XHCI_HC_LENGTH(p)	(((p)>>00)&0x00ff)
+
+/* Extended capability register fields */
+#define XHCI_EXT_CAPS_ID(p)	(((p)>>0)&0xff)
+#define XHCI_EXT_CAPS_NEXT(p)	(((p)>>8)&0xff)
+#define	XHCI_EXT_CAPS_VAL(p)	((p)>>16)
+/* Extended capability IDs - ID 0 reserved */
+#define XHCI_EXT_CAPS_LEGACY	1
+#define XHCI_EXT_CAPS_PROTOCOL	2
+#define XHCI_EXT_CAPS_PM	3
+#define XHCI_EXT_CAPS_VIRT	4
+#define XHCI_EXT_CAPS_ROUTE	5
+/* IDs 6-9 reserved */
+#define XHCI_EXT_CAPS_DEBUG	10
+/* Vendor caps */
+#define XHCI_EXT_CAPS_VENDOR_INTEL	192
+#define XHCI_EXT_CAPS_INTEL_SPR_SHADOW	206
+/* USB Legacy Support Capability - section 7.1.1 */
+#define XHCI_HC_BIOS_OWNED	(1 << 16)
+#define XHCI_HC_OS_OWNED	(1 << 24)
+
+/* USB Legacy Support Capability - section 7.1.1 */
+/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */
+#define XHCI_LEGACY_SUPPORT_OFFSET	(0x00)
+
+/* USB Legacy Support Control and Status Register  - section 7.1.2 */
+/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */
+#define XHCI_LEGACY_CONTROL_OFFSET	(0x04)
+/* bits 1:3, 5:12, and 17:19 need to be preserved; bits 21:28 should be zero */
+#define	XHCI_LEGACY_DISABLE_SMI		((0x7 << 1) + (0xff << 5) + (0x7 << 17))
+#define XHCI_LEGACY_SMI_EVENTS		(0x7 << 29)
+
+/* USB 2.0 xHCI 0.96 L1C capability - section 7.2.2.1.3.2 */
+#define XHCI_L1C               (1 << 16)
+
+/* USB 2.0 xHCI 1.0 hardware LMP capability - section 7.2.2.1.3.2 */
+#define XHCI_HLC               (1 << 19)
+#define XHCI_BLC               (1 << 20)
+
+/* Intel SPR shadow capability */
+#define XHCI_INTEL_SPR_ESS_PORT_OFFSET  0x8ac4	/* SuperSpeed port control */
+#define XHCI_INTEL_SPR_TUNEN	BIT(4)		/* Tunnel mode enabled */
+
+/* command register values to disable interrupts and halt the HC */
+/* start/stop HC execution - do not write unless HC is halted*/
+#define XHCI_CMD_RUN		(1 << 0)
+/* Event Interrupt Enable - get irq when EINT bit is set in USBSTS register */
+#define XHCI_CMD_EIE		(1 << 2)
+/* Host System Error Interrupt Enable - get irq when HSEIE bit set in USBSTS */
+#define XHCI_CMD_HSEIE		(1 << 3)
+/* Enable Wrap Event - '1' means xHC generates an event when MFINDEX wraps. */
+#define XHCI_CMD_EWE		(1 << 10)
+
+#define XHCI_IRQS		(XHCI_CMD_EIE | XHCI_CMD_HSEIE | XHCI_CMD_EWE)
+
+/* true: Controller Not Ready to accept doorbell or op reg writes after reset */
+#define XHCI_STS_CNR		(1 << 11)
+
+/**
+ * struct xhci_protocol_caps
+ * @revision:		major revision, minor revision, capability ID,
+ *			and next capability pointer.
+ * @name_string:	Four ASCII characters to say which spec this xHC
+ *			follows, typically "USB ".
+ * @port_info:		Port offset, count, and protocol-defined information.
+ */
+struct xhci_protocol_caps {
+	u32	revision;
+	u32	name_string;
+	u32	port_info;
+};
+
+#define	XHCI_EXT_PORT_MAJOR(x)	(((x) >> 24) & 0xff)
+#define	XHCI_EXT_PORT_MINOR(x)	(((x) >> 16) & 0xff)
+#define	XHCI_EXT_PORT_PSIC(x)	(((x) >> 28) & 0x0f)
+#define	XHCI_EXT_PORT_OFF(x)	((x) & 0xff)
+#define	XHCI_EXT_PORT_COUNT(x)	(((x) >> 8) & 0xff)
+
+#define	XHCI_EXT_PORT_PSIV(x)	(((x) >> 0) & 0x0f)
+#define	XHCI_EXT_PORT_PSIE(x)	(((x) >> 4) & 0x03)
+#define	XHCI_EXT_PORT_PLT(x)	(((x) >> 6) & 0x03)
+#define	XHCI_EXT_PORT_PFD(x)	(((x) >> 8) & 0x01)
+#define	XHCI_EXT_PORT_LP(x)	(((x) >> 14) & 0x03)
+#define	XHCI_EXT_PORT_PSIM(x)	(((x) >> 16) & 0xffff)
+
+#include <linux/io.h>
+
+/**
+ * Find the offset of the extended capabilities with capability ID id.
+ *
+ * @base	PCI MMIO registers base address.
+ * @start	address at which to start looking, (0 or HCC_PARAMS to start at
+ *		beginning of list)
+ * @id		Extended capability ID to search for, or 0 for the next
+ *		capability
+ *
+ * Returns the offset of the next matching extended capability structure.
+ * Some capabilities can occur several times, e.g., the XHCI_EXT_CAPS_PROTOCOL,
+ * and this provides a way to find them all.
+ */
+
+static inline int xhci_find_next_ext_cap(void __iomem *base, u32 start, int id)
+{
+	u32 val;
+	u32 next;
+	u32 offset;
+
+	offset = start;
+	if (!start || start == XHCI_HCC_PARAMS_OFFSET) {
+		val = readl(base + XHCI_HCC_PARAMS_OFFSET);
+		if (val == ~0)
+			return 0;
+		offset = XHCI_HCC_EXT_CAPS(val) << 2;
+		if (!offset)
+			return 0;
+	}
+	do {
+		val = readl(base + offset);
+		if (val == ~0)
+			return 0;
+		if (offset != start && (id == 0 || XHCI_EXT_CAPS_ID(val) == id))
+			return offset;
+
+		next = XHCI_EXT_CAPS_NEXT(val);
+		offset += next << 2;
+	} while (next);
+
+	return 0;
+}
-- 
2.53.0
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.