[PATCH v10 12/17] riscv: dts: spacemit: k1-musepi-pro: add SD card support with UHS modes
Eric Chung <[email protected]>
| Newsgroups | org.u-boot-project.lists.u-boot |
|---|---|
| Message-ID | <[email protected]> |
From: Trevor Gamblin <[email protected]> Update the Muse Pi Pro devicetree with SD card support to match what was done for the OrangePi RV2 in [1]. More precisely: - Enable sdhci0 controller with 4-bit bus width - Configure card detect GPIO with internal pull-up support - Connect vmmc-supply to buck4 for 3.3V card power - Connect vqmmc-supply to aldo1 for 1.8V/3.3V I/O switching - Add dual pinctrl states for voltage-dependent pin configuration - Support UHS-I SDR25, SDR50, and SDR104 modes - Add stable MMC device aliases (mmc0 = eMMC, mmc1 = SD card) [1] https://lore.kernel.org/linux-riscv/[email protected]/T/# Tested-by: Andre Heider <[email protected]> Signed-off-by: Trevor Gamblin <[email protected]> Signed-off-by: Iker Pedrosa <[email protected]> Signed-off-by: Andre Heider <[email protected]> Link: https://lore.kernel.org/linux-riscv/[email protected]/T/# Link: https://patch.msgid.link/[email protected] Signed-off-by: Yixun Lan <[email protected]> [ upstream commit: 85e4c5733cd7efa39f10d7200095c016ce4a2815 ] (cherry picked from commit 9f9e7116bf6057433905f05a6ea06dd17a4b41c4) --- dts/upstream/src/riscv/spacemit/k1-musepi-pro.dts | 22 +++++++++++++++++++++- 1 file changed, 21 insertions(+), 1 deletion(-) diff --git a/dts/upstream/src/riscv/spacemit/k1-musepi-pro.dts b/dts/upstream/src/riscv/spacemit/k1-musepi-pro.dts index 4aef287353ca..0d809e4ad3b1 100644 --- a/dts/upstream/src/riscv/spacemit/k1-musepi-pro.dts +++ b/dts/upstream/src/riscv/spacemit/k1-musepi-pro.dts @@ -19,6 +19,8 @@ serial0 = &uart0; i2c2 = &i2c2; i2c8 = &i2c8; + mmc0 = &emmc; + mmc1 = &sdhci0; }; chosen { @@ -218,7 +220,7 @@ regulator-always-on; }; - aldo1 { + aldo1: aldo1 { regulator-min-microvolt = <500000>; regulator-max-microvolt = <3400000>; regulator-boot-on; @@ -384,3 +386,21 @@ reset-gpios = <&gpio K1_GPIO(123) GPIO_ACTIVE_LOW>; /* HUB_RST */ }; }; + +&sdhci0 { + pinctrl-names = "default", "uhs"; + pinctrl-0 = <&mmc1_cfg>; + pinctrl-1 = <&mmc1_uhs_cfg>; + bus-width = <4>; + cd-gpios = <&gpio K1_GPIO(80) (GPIO_ACTIVE_HIGH | GPIO_PULL_UP)>; + no-mmc; + no-sdio; + disable-wp; + cap-sd-highspeed; + vmmc-supply = <&buck4_3v3>; + vqmmc-supply = <&aldo1>; + sd-uhs-sdr25; + sd-uhs-sdr50; + sd-uhs-sdr104; + status = "okay"; +}; -- 2.51.0