[PATCH v10 14/17] configs: k1: enable SD and eMMC support
Eric Chung <[email protected]>
| Newsgroups | org.u-boot-project.lists.u-boot |
|---|---|
| Message-ID | <[email protected]> |
Enable high-speed MMC modes. Signed-off-by: Eric Chung <[email protected]> --- v7: - Remove the change on MAINTAINERS. - Force DM to use alias by CONFIG_DM_SEQ_ALIAS. Since the sequence of mmc devices in DTS are inverted by alias. v5: - Remove ADMA support since it depends on CMD23 support. - Enable PINCONF support for related power source setting. v2: - Enable ADMA support. - Enable SYSCON support. --- configs/spacemit_k1_defconfig | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+) diff --git a/configs/spacemit_k1_defconfig b/configs/spacemit_k1_defconfig index 0604c2feefc1..5f9923c7f470 100644 --- a/configs/spacemit_k1_defconfig +++ b/configs/spacemit_k1_defconfig @@ -23,6 +23,7 @@ CONFIG_DEBUG_UART_BASE=0xd4017000 CONFIG_DEBUG_UART_CLOCK=14700000 CONFIG_TARGET_SPACEMIT_K1=y CONFIG_ARCH_RV64I=y +CONFIG_RISCV_ISA_ZICBOM=y CONFIG_RISCV_SMODE=y CONFIG_SPL_RISCV_MMODE=y # CONFIG_SPL_SMP is not set @@ -48,6 +49,7 @@ CONFIG_SPL_CMD_TLV_EEPROM=y CONFIG_OF_UPSTREAM=y CONFIG_ENV_OVERWRITE=y CONFIG_SPL_REGMAP=y +CONFIG_SYSCON=y CONFIG_SPL_SYSCON=y CONFIG_CLK=y CONFIG_CLK_CCF=y @@ -61,6 +63,7 @@ CONFIG_MISC=y CONFIG_I2C_EEPROM=y CONFIG_SPL_I2C_EEPROM=y CONFIG_PINCTRL=y +CONFIG_PINCONF=y CONFIG_PINCTRL_SPACEMIT_K1=y CONFIG_GPIO=y CONFIG_DM_GPIO=y @@ -87,9 +90,28 @@ CONFIG_SPI_FLASH_WINBOND=y CONFIG_SPI_MEM=y CONFIG_SYS_SPI_U_BOOT_OFFS=0x000a0000 CONFIG_CMD_SPI=y +CONFIG_DM_SEQ_ALIAS=y +CONFIG_MMC=y +CONFIG_MMC_SDHCI=y +CONFIG_MMC_SDHCI_SPACEMIT=y +CONFIG_MMC_IO_VOLTAGE=y +CONFIG_MMC_HS200_SUPPORT=y +CONFIG_MMC_HS400_SUPPORT=y +CONFIG_MMC_HS400_ES_SUPPORT=y +CONFIG_SUPPORT_EMMC_BOOT=y +CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION=y +CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION=0x4 +CONFIG_CMD_MMC=y +CONFIG_CMD_MEMINFO=y +CONFIG_CMD_MEMINFO_MAP=y +CONFIG_EFI_PARTITION=y CONFIG_SPL_SPI=y CONFIG_SPL_DM_SPI=y CONFIG_SPL_DM_SPI_FLASH=y CONFIG_SPL_SPI_LOAD=y CONFIG_SPL_SPI_FLASH_TINY=y CONFIG_SPL_SPI_FLASH_SUPPORT=y +CONFIG_SPL_BOARD_INIT=y +CONFIG_SPL_DM_SEQ_ALIAS=y +CONFIG_SPL_MMC=y +CONFIG_SPL_SYS_MMCSD_RAW_MODE=y -- 2.51.0