Re: [PATCH v6 12/36] KVM: x86: Restructure get_kvmclock()

On Fri, 2026-07-24 at 14:29 -0700, Sean Christopherson wrote:
>  
> > Given that, the get_cpu()/put_cpu() pinning is not needed either: both
> > the TSC read and get_cpu_tsc_khz() are CPU-independent when the master
> > clock is in use, so drop them.
> > 
> > Wrap the entire use_master_clock block in #ifdef CONFIG_X86_64, since
> > use_master_clock is never true on 32-bit (host_tsc_clocksource is only
> > set under CONFIG_X86_64), and declare hv_clock inside the block so it is
> > not left as an unused variable on 32-bit.
> > 
> > Use 'continue' on the master-clock success path so the non-master-clock
> > computation becomes the common tail, avoiding a goto and label. When the
> > clock read fails (e.g. clocksource transitioning away from TSC), fall
> > back to that path rather than proceeding with uninitialised data or
> > spinning in the seqcount loop.
> 
> Please split this up.  The changelog suggests there are at least three logical
> changes here.  Yeah, the series is big, but smaller patches helps with review,
> even if it results in more total patches.

I don't think the latter two are separable; the refactoring of the
ifdef and the loop and the way it breaks out to the tail are all
intertwined. I may be able to pull the get_cpu()/get_cpu_tsc_khz() part
out into a preliminary commit though. I'll take a look.