Solaris 64bit module problem

Hello,

A built perl-5.8.0 on solaris using theese commands:

-- CUT --
sh Configure -Dcc=gcc -des -Duse64bitall \
        -Dprefix=/export/home/prints/Vlada/perl \
        -Uinstallusrbinperl \
        -Dcc=gcc \
        -Dusethreads \
        > Configure.log 2>&1

sh Configure -Dcc=gcc -des -Duse64bitall \
        -Dprefix=/export/home/prints/Vlada/perl \
        -Uinstallusrbinperl \
        -Dcc=gcc \
        -Dusethreads \
        -A ldflags=-m64 \
        -A lddlflags=-m64 \
        >> Configure.log 2>&1

make
make test
make install
-- CUT--

I don't understand why I have to call Configure twice, and maybe this is
wron. But perl compiles fine, and all tests went fine too.

After that, I chdir to module I want to compile.

# /export/home/prints/Vlada/perl/bin/perl Makefile.PL
# make
# make test

Can't load '../blib/arch/auto/NCLMessage/NCLMessage.so' for module
NCLMessage: ld.so.1: /export/home/prints/Vlada/perl/bin/perl: fatal:
../blib/arch/auto/NCLMessage/NCLMessage.so: required mapping 0x100000000
size 0x116000, is already in use by file
/export/home/prints/Vlada/perl/bin/perl at
/export/home/prints/Vlada/perl/lib/5.8.0/sun4-solaris-thread-multi/DynaLoader.pm
line 229.

# uname -a
SunOS hkpress1 5.9 Generic_112233-05 sun4u sparc SUNW,Sun-Fire-480R

Any other info which could be usefull ?

Couldn't you give me any hint please ? :)

Also I realize that probably I'm on wrong list (maybe it's not perl
releated even ?), but since I don't have big experience witch solaris, I
seek politely for an advice here ...

-- 
	Vladimír Marek