Re: Perl install problems OSX 10.4.11

Hi,

Thanks for your excellent response, makes installing so easy assuming  
I did it correctly.
I think everything that was required is installed, but I am not sure  
everything was installed
in the right location.

It appears that Perl 5.10.1 was installed and all the modules I  
installed are associated with
Perl 5.10.1. When I try to run the get_iplayer PVR module I get the  
following error:
Can't locate loadable object for module HTML::Parser in @INC (@INC  
contains: /opt/local/lib/perl5/5.8.8/darwin-2level
(I have abbreviated the error message)

And when I enter perl -v  I get the following:
This is perl, v5.8.8 built for darwin-2level

So the system does not see the Perl 5.10.1 install. Can someone  
please tell me if there is a
was to install the modules so they relate to perl, v5.8.8, or point  
get_iplayer to use Perl 5.10.1.

Thanks,

Terrence



On 12 Sep 2009, at 05:02, Packy Anderson wrote:

> On Sep 11, 2009, at 5:33 PM, Mine wrote:
>> I don't fully understand what Perl does but if Perl comes  
>> installed with OSX
>> it appears that I also have an install of Perl via MacPorts. I  
>> assume that
>> get_iplayer is looking at the preinstalled Perl but I am not sure.
>
> Perl is a programming language, and it appears that get_iplayer is  
> written in it.
>
> The perl that comes installed with OS X is located at /usr/bin/ 
> perl.  If you've also installed perl from some other source (like  
> MacPorts) then you might have another perl at some other location.
>
> I've taken a look at the iplayer source (available through http:// 
> linuxcentre.net/getiplayer/) and it's definitely using the Perl  
> that comes with OS X at /usr/bin/perl/
>
>> Although I am no expert, I have used the Terminal to install  
>> binaries before
>> so i will give it a go.
>
> It's fairly simple.  Type
>
>   sudo perl -MCPAN -e shell
>
> At a Terminal prompt and enter in your password when prompted.   
> You'll be asked to configure CPAN the first time you run it; just  
> take the defaults and you'll be fine.  Then, once you get a "cpan[1] 
> >" command prompt, type the following:
>
>   cpan[1]> install LWP
>
> and hit enter.  It will automatically figure out what prerequisites  
> you need and download all the packages.  Again, I generally take  
> the defaults and everything works well.
>
> -packy