script does not give me the output

Hello,

I installed Macperl and used it to run a script. But the script didn't return
me any output although one of it's first commands is printing it's name to
STDOUT. Then I installed the Aplha editor mentioned in the FAQ and used the
function "Save and Run" there. But again I didn't get some output. Even when
I call "Get output" I don't get it.

After that, I changed the script by adding the lines

print "hello world";
die;

at the beginning (only a few comments before). Again no output.

An other script with only a the line
print "hello world" 
runs fine and gives me the expceted output.

Can someone help me?

Thanks in advance,
Jan Theofel

-- 
Jan Theofel                              Fon:  +49 (7 11) 48 90 83 - 0
ETES - EDV-Systemhaus GbR                Fax:  +49 (7 11) 48 90 83 - 50
Libanonstrasse 58 A * D-70184 Stuttgart  Web: http://www.etes.de

______________________________________
Inflex - eMail Scanning and Protection
Queries to: [email protected]