Rebuilding config_h.SH

In order to get in sync, I rebuilt config_h.SH with metaconfig, and the
content was the same, but reshuffled (reordered)

This cause HAS_QUAD to be too far down and also LONGLONG to be used before
defined

The deps in byteorder.U were questionable, but adding longsize to the deps
(and using it in comments to have it validated) didn't help a bit.

perlxv.U has all the deps where I expect them to be

Is there, other than the deps, any way to influence the order in config_h.SH?
If so, where? Or is it manual intervention afterwards, and does that need to
be documented in a reame or so. I cannot find it.

modified/Config_h.U and modified/Config_sh.U don't hint me to anything useful
either

-- 
H.Merijn Brand        Amsterdam Perl Mongers (http://amsterdam.pm.org/)
using perl-5.6.1, 5.8.5, & 5.9.x, and 809 on  HP-UX 10.20 & 11.00, 11i,
   AIX 4.3, AIX 5.2, SuSE 9.1, and Win2k.  http://www.cmve.net/~merijn/
http://archives.develooper.com/[email protected]/   [email protected]
send smoke reports to: [email protected], QA: http://qa.perl.org