Put metaconfig sources under SVN on sourceforge

Hello perl5 builders,

I've revived the "dist" project since I've been using metaconfig and
jmake on another project of mine for several years.

Ideally, I'd like to be able to retrofit some of the configuration
knowledge gathered by having Configure run on as many platforms as
possible.

The sources are available under subversion.  To access them, you
can run the following:

	svn co https://svn.sourceforge.net/svnroot/dist/trunk/dist

It would be good if the current maintainers of the metaconfig units
for Perl could join the "dist" project.  I'll give you SVN write
access.

I've also setup a mailing list "[email protected]" where
SVN commit messages along with patches will be sent.

Finally, I've created a #dist IRC channel on irc.freenode.net where
commit messages will be automatically issued.

Thanks,
Raphael