new install of linuxcnc, which is debian 10 based

Greetings all;

One of the first things extra I installed was amanda-common and 
amanda-client from the debian repos.

But the install did not generate a /home/gene/linuxcnc directory which is 
the base of its config and data trees.

So I go to "sudo amrecover" in order to recover that whole tree.
But, amrecover won't run because it can't find ambind, a utility I am not 
aware of.  So, start me up from square one to bring amanda back online 
in a new install please. I have not yet created an amandahosts file or 
anything else the installer didn't set up.

Thanks All.

Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>