Re: new install of linuxcnc, which is debian 10 based

On Tuesday 29 September 2020 17:36:48 you wrote:
CC:back on list so its archived.

> On Tue, 29 Sep 2020 16:45:15 -0400
>
> Gene Heskett <[email protected]> wrote:
> > But the install did not generate a /home/gene/linuxcnc directory
> > which is the base of its config and data trees.
>
> Can't help you with that....
>
> > So I go to "sudo amrecover" in order to recover that whole tree.
> > But, amrecover won't run because it can't find ambind, a utility I
> > am not aware of.  So, start me up from square one to bring amanda
> > back online in a new install please. I have not yet created an
> > amandahosts file or anything else the installer didn't set up.
>
> On Debian 10 (buster) as updated:
>
> charles@hawk:~$ locate ambind
> /usr/lib/amanda/ambind
> charles@hawk:~$ apt-file search ambind
> amanda-server: /usr/lib/amanda/ambind

This is a pure client, thats in amanda-server. I don't think any of the 
other clients have the server installed.

This is a clue I think.  Thanks.

> charles@hawk:~$$ pre amanda
> amanda-client	1:3.5.1-2+b2		amd64
> amanda-common	1:3.5.1-2+b2		amd64
> amanda-server	1:3.5.1-2+b2		amd64
> charles@hawk:~$

printed so I can check it the next time I go up the hill, probably 
tomorrow now.  Thank you Charles.

Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>