Re: Amrecover hangs after restore

"Stefan G. Weichinger" <[email protected]> Wed, 25 Nov 2020 18:37:56 +0100

Newsgroups	gmane.comp.archivers.amanda.user
Message-ID	<[email protected]>

Am 25.11.20 um 18:26 schrieb Charles Curley:
> On Wed, 25 Nov 2020 18:06:09 +0100
> "Stefan G. Weichinger" <[email protected]> wrote:
> 
>> Am 30.05.18 um 20:21 schrieb Jason L Tibbitts III:
> 
> ...
> 
>>>
>>> [... time passes and I see a byte count increasing ...]
>>>
>>> /usr/bin/pigz: pigz: warning: <stdin>: trailing junk was ignored
>>> ```
>>>
> 
> I've had problems with pigz in the past. Try replacing it with plain
> vanilla gzip.

Does it work to edit the dumptype and restore then?

The backup on tape contains the information that it was written with
pigz ... I am not sure if amanda also reads that at recover/restore or
only follows the dumptype config.

thanks