Re: Amrecover hangs after restore
"Stefan G. Weichinger" <[email protected]>
| Newsgroups | gmane.comp.archivers.amanda.user |
|---|---|
| Message-ID | <[email protected]> |
Am 25.11.20 um 18:37 schrieb Stefan G. Weichinger: > Am 25.11.20 um 18:26 schrieb Charles Curley: >> On Wed, 25 Nov 2020 18:06:09 +0100 >> "Stefan G. Weichinger" <[email protected]> wrote: >> >>> Am 30.05.18 um 20:21 schrieb Jason L Tibbitts III: >> >> ... >> >>>> >>>> [... time passes and I see a byte count increasing ...] >>>> >>>> /usr/bin/pigz: pigz: warning: <stdin>: trailing junk was ignored >>>> ``` >>>> >> >> I've had problems with pigz in the past. Try replacing it with plain >> vanilla gzip. > > Does it work to edit the dumptype and restore then? > > The backup on tape contains the information that it was written with > pigz ... I am not sure if amanda also reads that at recover/restore or > only follows the dumptype config. Tried it. Does not work to only edit that dumptype, amrecover seems to read the meta-info/header of the dump on tape. Same failure. I'd also prefer to benefit of the parallelity of pigz at compression time.