Re: Ardour3-3.1 does not build on FreeBSD i386 10.0

this should already be fixed by the use of '-DBOOST_SYSTEM_NO_DEPRECATED'
for CFLAGS and CXXFLAGS.


On Thu, Jun 20, 2013 at 6:31 PM, outro pessoa <[email protected]>wrote:

> I ran into a problem similar to this one:
> https://bugs.gentoo.org/show_bug.cgi?id=425578 with the same type of
> results.  Can this be approached from a configuration directory such as
> $PORTS_PATH/ardour-betaX or will it need to be done within the top level
> wscript file? I am aware that the old Scons build system was used and is
> referenced; but, I am looking for a solution similar to the problem I am
> encountering.
>
> Thanks and all for the help and advice so far.
>
>
> On Tue, Jun 18, 2013 at 7:38 PM, Paul Davis <[email protected]>wrote:
>
>>
>>
>>
>> On Tue, Jun 18, 2013 at 6:46 PM, outro pessoa <[email protected]>wrote:
>>
>>> I set clang, clang++, and clang-cpp with the full paths in the
>>> $PORT/Makefile.
>>> Another question...
>>> "$ ./ardev
>>> .: cannot open ./../build/gtk2_ardour/ardev_common_waf.sh: No such file
>>> or directory
>>> $ "
>>>
>>>
>>> http://pkgsubmit.mageia.org/autobuild/cauldron/x86_64/core/log/ardour3-3.0-0.13700.2.mga3.src.rpm/build.0.20130209132846.log
>>> had the exact same thing. The page is gone though.
>>>
>>> Does this require a link to a top level directory?
>>>
>>
>> no, it means that your build didn't work.
>> ../build/gtk2_ardour/ardev_common_waf.sh is a build target.
>>
>>
>
>

_______________________________________________
ardour-dev mailing list
[email protected]
http://lists.ardour.org/listinfo.cgi/ardour-dev-ardour.org