Re: No Audition in Apple Loops

If you put Logic in play (with an empty track solo'd so you can hear  
the loop), most loops will play when you highlight them

On May 27, 2008, at 11:52 PM, Music wrote:

> Dear All,
>
>  I don't know if this has been covered before, but I've always had the
>  following problem:
>
>  when I open Apple Loops (in Logic Pro 7 or 8) sometimes I get the
>  audition by clicking on the relevant loop within the Loop Browser and
>  it plays back without any problems and now, most of the times I get no
>  audio unless I drag the loop into a Direct TDM track.
>
>  I've always used the same autoload song and I can't understand how
>  this works. It's obviously very tedious to drag all the loops I want
>  to listen to into the arrange window.
>
>  Any suggestion would be very much appreciated
>
>  
>       

[Non-text portions of this message have been removed]


------------------------------------

________________________________________________________________________
Logic TDM Users Group - new forums! http://logic-users.org/forums/L-TDM
- To UNSUBSCRIBE: email [email protected]
- Search the entire archive: http://logic-users.org/forums/L-TDM/searchYahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/logic-tdm/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/logic-tdm/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/