Changing the tempo

Hello,

jayfolland has just posted in the Logic 9 forum of Logic Users Group under the title of Changing the tempo.

This thread is located at http://www.logic-users-group.com/forums/showthread.php?t=5045

Here is the message that has just been posted:
***************
Hi,

I had some Audio files that were recorded in logic, Around 122BPM.
SO I imported them into a new session which I wanted to be around 141BPM.
So once I imported them I the selected each file to be at it's "original record position", then I activated elastic audio and changed the tempo, All was good, everything was in time no worries. Is this the best way? (Or should I of changed the session to the original tempo then selected follow tempo in the inspector, correct me if I'm wrong but I think the elastic Audio has less artifacts?)

My main problem is, I then needed another file later on in the session, but the only way I could figure out how to adjust that file to the tempo was-Create another session and do the same as I did above and then bounce that file then import it into my current session? But creating another session and doing that is really time consuming, there must be an easier way?

Thanks,
Jay
***************


------------------------------------

The LUG has a new home on the web,  to visit and sign up please go to:

http://www.logic-users-group.com/











Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/logic-users/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/logic-users/join
    (Yahoo! ID required)

<*> To change settings via email:
    [email protected] 
    [email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/