Re: [SoundDiver] JLCooper MSB 16/20 and/or MSB+ Rev2 with Sounddiver
"neurokrash" <[email protected]>
| Newsgroups | gmane.comp.audio.emagic.sounddiver |
|---|---|
| Message-ID | <[email protected]> |
--- In [email protected], "Mark Earwood" <mark.earwood@...> wrote: > > Hi > > I use an MSB 16/20 with s/diver (on an Atari- but the principle is the > same) > > There is an adaptation for the JLCooper. You have to use it in patchbay > mode (in SD), and there are some settings on the unit itself to change > whether you want to control the JLC remotely, or just as a patchbay. > > I've not switched on for a while, but all details are in the manuals. I > do remember a lot of head scratching setting this up. Getting my head round > the in's turning into out's, and vice versa, the base 8 numbering of the > patch selection, or the non standard hex numbering they used for selecting > outputs on the front panel, which if I remember were offset by 1 just to > make it interesting. > > Check the manuals. Good luck. Greetings, After a ridiculous amount of trial and error, I think that I may have figured this out. It was all reliant on specific patches being programmed into the MSB, and putting the cables in the right places. I sort of assumed that Sounddiver would be able to scan and figure out how things were connected, but I was wrong. The manual (all 11 pages or so) was not very helpful - the term non-intuitive comes to mind. The Sounddiver manual basically re-states the same lines from the manual, rather than - oh, saying what settings to use to actually get this to work. It is so convoluted I'm going to have to take photos and screenshots or I'm sure I'll have trouble figuring this out again. At the moment, I do have two instruments all hooked up, responding, switching, and able to access store or edit sounds. Once the rest of the MIDI cables arrive, we'll see what happens. Thanks! ------------------------------------ ________________________________________________________________________ SoundDiver Users Group - new forums! http://logic-users.org/forums/SD - To UNSUBSCRIBE: email sounddiver-users-unsubscribe-hHKSG33TihhbjbujkaE4pw@public.gmane.org - Search the entire archive: http://logic-users.org/forums/SD/searchYahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/sounddiver-users/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/sounddiver-users/join (Yahoo! ID required) <*> To change settings via email: mailto:[email protected] mailto:sounddiver-users-fullfeatured-hHKSG33TihhbjbujkaE4pw@public.gmane.org <*> To unsubscribe from this group, send an email to: sounddiver-users-unsubscribe-hHKSG33TihhbjbujkaE4pw@public.gmane.org <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/