[ lame-Support Requests-3493406 ] About floating point VBR settings...

Support Requests item #3493406, was opened at 2012-02-24 12:37
Message generated for change (Tracker Item Submitted) made by eblanca76
You can respond by visiting: 
https://sourceforge.net/tracker/?func=detail&atid=200290&aid=3493406&group_id=290

Please note that this message will contain a full copy of the comment thread,
including the initial issue submission, for this request,
not just the latest update.
Category: None
Group: None
Status: Open
Priority: 5
Private: No
Submitted By: Elio Blanca (eblanca76)
Assigned to: Nobody/Anonymous (nobody)
Summary: About floating point VBR settings...

Initial Comment:
I see recent lame releases added support for floating point values for the vbr switch `-V', and the floating point part is used to fine tune the lowpass frequency.
About this feature, is some detail added into the lame tag? I mean, since a modification in the floating point part affects the lowpass freq (which is already stored into the lame tag) is there a particular way for checking if a floating point vbr value was used?


----------------------------------------------------------------------

You can respond by visiting: 
https://sourceforge.net/tracker/?func=detail&atid=200290&aid=3493406&group_id=290

------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing 
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/