Re: Configuring a Checked out Zinf

You need to use the autogen script which will create
a configure script.   When building from CVS you need
to have most optional packages installed so that the
configure script is created correctly (the configure
script tests for the existance of the optional packages).

Also make sure you are using a recent automake(>1.7)/autoconf(2.50)


After installing optional packages (even if you don't plan
on building support for them).

>From top level:
autogen.sh
mkdir build; cd build
../configure
make

When it's done you can run it within the zinf build  dir with
./base/zinf



On Thu, 2003-08-07 at 09:37, Steve Holmes wrote:
> I just successfully checked out a zinf module but there is no
> configure script.  Do I have to autogen something? if so, what params
> do I use? When I ran autogen.sh with no params, I got a configure
> script but there was a whole bunch of warnings and errors and when I
> did a diff between this one and the original configure in zinf-2.2.4,
> the resulting differences was HUGE!  What should I do here? can I just
> use the configure out of 2.2.4 without any problems?
> 
> Thanks.  This is my first time with zinf from a CVS tree.
-- 
Kristian G. Kvilekval
email:[email protected] office:(805)893-4276 http://www.cs.ucsb.edu/~kris



-------------------------------------------------------
This SF.Net email sponsored by: Free pre-built ASP.NET sites including
Data Reports, E-commerce, Portals, and Forums are available now.
Download today and enter to win an XBOX or Visual Studio .NET.
http://aspnet.click-url.com/go/psa00100003ave/direct;at.aspnet_072303_01/01