set-strength-limit
Rick Giuly <[email protected]>
| Newsgroups | gmane.comp.breve |
|---|---|
| Message-ID | <[email protected]> |
(1) get-strength-hard-limit Returns the "hard" limit of the joint--the maximum torque that you are allowed to put on a single joint. Does this mean if you put too much, it will break or breve will just use a lower torque. (2) could we have a set-torque method? :) -Rick _______________________________________________ breve mailing list [email protected] http://www.spiderland.org/mailman/listinfo/breve