Re: set-strength-limit
William Taysom <[email protected]>
| Newsgroups | gmane.comp.breve |
|---|---|
| Message-ID | <[email protected]> |
> (1) > get-strength-hard-limit > > Returns the "hard" limit of the joint--the maximum torque that you are > allowed > to put on a single joint. > > Does this mean if you put too much, it will break or breve will just > use a > lower torque. No, you get a divide by zero, and Breve breaks! _______________________________________________ breve mailing list [email protected] http://www.spiderland.org/mailman/listinfo/breve