Re: set-strength-limit
jon klein <[email protected]>
| Newsgroups | gmane.comp.breve |
|---|---|
| Message-ID | <[email protected]> |
On Jun 11, 2004, at 11:35 PM, Rick Giuly wrote: > (2) > could we have a set-torque method? :) The revolute joint does have one: http://www.spiderland.org/breve/docs/classes/RevoluteJoint.html#set- joint-torque I'll see if I can add one for the UniversalJoint and BallJoint for the next release. On Jun 11, 2004, at 11:39 PM, William Taysom wrote: >> Does this mean if you put too much, it will break or breve will just >> use a >> lower torque. > > No, you get a divide by zero, and Breve breaks! Yikes! I'll have to take care of that as well! - jon klein _______________________________________________ breve mailing list [email protected] http://www.spiderland.org/mailman/listinfo/breve