Re: set-strength-limit
William Taysom <[email protected]>
| Newsgroups | gmane.comp.breve |
|---|---|
| Message-ID | <[email protected]> |
> On Jun 11, 2004, at 11:39 PM, William Taysom wrote: > >>> Does this mean if you put too much, it will break or breve will just >>> use a >>> lower torque. >> >> No, you get a divide by zero, and Breve breaks! > > Yikes! I'll have to take care of that as well! I don't know this for a fact. However, when experimenting with the physics a little. (Take the ball dropping example, change the balls to rectangular solids, and dispose of them less frequently if at all. When I did this, I was able to get Breve to reliably crash. Sometimes it would take more time, sometimes less, but a few seconds was always enough.) _______________________________________________ breve mailing list [email protected] http://www.spiderland.org/mailman/listinfo/breve