joint-limits on ball-joints

Hello.
Joint limits don't seem to work properly on ball
joints.
Anything other than 0 allows complete rotation. for
example: min(-0.1,0,0) max(0,0,0) allows unlimited
negative rotation on the x-axis.
Using set-strength-limit helps some, but still doesn't
always stay within limits.
Has anyone else noticed this?

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
breve mailing list
[email protected]
http://lists.spiderland.org/mailman/listinfo/breve