How do I use GNU AutoTools?
samuel ammonius <[email protected]>
| Newsgroups | gmane.comp.desktop.xfce.devel.version4 |
|---|---|
| Message-ID | <CALbUA4g_aX12v-L2ttnyZfE_Mh9LZTnijvH4o=Ch7njfY2iE2Q@mail.gmail.com> |
Hi. I hope this isn't too off-topic, but I came from this forum thread <https://forum.xfce.org/viewtopic.php?pid=67991#p67991> hoping to find out how to use autotools for a fork of XFCE that I was hoping to make. I have a few questions: 1. Is it ok if I just use CMake or is there a reason that XFCE uses autotools (is the reason just that CMake wasn't available when XFCE was created?) 2. If CMake is a bad option, how do I actually use autotools? _______________________________________________ Xfce4-dev mailing list [email protected] https://mail.xfce.org/mailman/listinfo/xfce4-dev