Re: How do I use GNU AutoTools?
Alexander Schwinn <[email protected]>
| Newsgroups | gmane.comp.desktop.xfce.devel.version4 |
|---|---|
| Message-ID | <[email protected]> |
If you anyhow want to start from scratch, I would suggest using meson. cmake imo is just a different hell / not any better than autotools, Cheers, Alex Am 11. Juli 2022 14:11:43 MESZ schrieb samuel ammonius <[email protected]>: >Hi. I hope this isn't too off-topic, but I came from this forum thread ><https://forum.xfce.org/viewtopic.php?pid=67991#p67991> hoping to find out >how to use autotools for a fork of XFCE that I was hoping to make. I have a >few questions: > > 1. Is it ok if I just use CMake or is there a reason that XFCE uses > autotools (is the reason just that CMake wasn't available when XFCE was > created?) > 2. If CMake is a bad option, how do I actually use autotools? _______________________________________________ Xfce4-dev mailing list [email protected] https://mail.xfce.org/mailman/listinfo/xfce4-dev