Re: Help with E1000 bochsrc for redhat image

La experiencia en bochs me dice q et miris la configuracio amb la que ho
vas compilar.

Mira els drivers pel dispositiu a part.

Has preguntat pel foro de bochs al sourceforge?
El 09/06/2015 19:31, "Mark Reynolds" <[email protected]> escribió:

>
> Host: Ubuntu 14.04_2
> Guest: Redhat Linux 6.0
>
> I have the following in my bochsrc for networking:
>
> pci: enabled=1, chipset=i440fx, slot1=cirrus, slot2=e1000
>
> e1000: enabled=1, ioaddr=0x300, irq=5, mac=b0:c4:20:00:00:00,
> ethmod=linux, ethdev=eth0
>
> When I boot redhat only the interface "lo" is present. In the bochs log it
> continually
> says "device not ready to receive data".
>
> Any suggestions would be greatly appreciated.
>
> - Mark
>
>
> ------------------------------------------------------------------------------
>
> _______________________________________________
> bochs-developers mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/bochs-developers
>
>

------------------------------------------------------------------------------

_______________________________________________
bochs-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bochs-developers