Re: Help with E1000 bochsrc for redhat image

Hello!
I'm not sure if Mark will get it. I'm certainly not getting it. Can
you please restate what your wanted to say in English?
-----
Gregg C Levine [email protected]
"This signature fought the Time Wars, time and again."


On Tue, Jun 9, 2015 at 3:20 PM, dunedain1990 <[email protected]> wrote:
> La experiencia en bochs me dice q et miris la configuracio amb la que ho vas
> compilar.
>
> Mira els drivers pel dispositiu a part.
>
> Has preguntat pel foro de bochs al sourceforge?
>
> El 09/06/2015 19:31, "Mark Reynolds" <[email protected]> escribió:
>>
>>
>> Host: Ubuntu 14.04_2
>> Guest: Redhat Linux 6.0
>>
>> I have the following in my bochsrc for networking:
>>
>> pci: enabled=1, chipset=i440fx, slot1=cirrus, slot2=e1000
>>
>> e1000: enabled=1, ioaddr=0x300, irq=5, mac=b0:c4:20:00:00:00,
>> ethmod=linux, ethdev=eth0
>>
>> When I boot redhat only the interface "lo" is present. In the bochs log it
>> continually
>> says "device not ready to receive data".
>>
>> Any suggestions would be greatly appreciated.
>>
>> - Mark
>>
>>
>> ------------------------------------------------------------------------------
>>
>> _______________________________________________
>> bochs-developers mailing list
>> [email protected]
>> https://lists.sourceforge.net/lists/listinfo/bochs-developers
>>
>
> ------------------------------------------------------------------------------
>
> _______________________________________________
> bochs-developers mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/bochs-developers
>

------------------------------------------------------------------------------
_______________________________________________
bochs-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bochs-developers