Re: Re: Problems with IPL-ing 1.13 ( again)

I really think it's  either / and your LOADPARM and / or your device #'s

I would try hard coding the LOADPARM

Or if you want to use the hercules loadparm command,  I *think* you
need to include the IODF device address  along with the parameter:

eg.
LOADPARM   0380pppp

or
LOADPARM   0A82pppp


I tried putting just   LOADPARM   CS   in my hercules.cnf (instead of
0A95CS..) and got a disabled wait state 'B3'

On 5/25/19, gheorghedragos1988-/[email protected] [hercules-390]
<[email protected]> wrote:
> Michael,
>
> I will try. However, just to eliminate all possibilities, I have performed
> ipl saying that the sys res is on SARES1. It throws a completely different
> error. When I used a made up loadparm it shows a completely different error.
> When I use correct load parm and sys res it throws 31.
>
> Play this one ...