Re: Re: Problems with IPL-ing 1.13 ( again)
| Newsgroups | gmane.comp.emulators.hercules390.general |
|---|---|
| Message-ID | <CAA5vqSYvTw3zNBXG+aKTLgA5GVcpqS=MQR2A_xLTa1+5pa42hw@mail.gmail.com> |
>I have performed ipl saying that the sys res is on SARES1. Well that's obviously not going to work if SARES1 is not the "sys res" (doesn't have SYS1.NUCLEUS) on it. Mike On 5/25/19, Mike Stramba <[email protected]> wrote: > I really think it's either / and your LOADPARM and / or your device #'s > > I would try hard coding the LOADPARM > > Or if you want to use the hercules loadparm command, I *think* you > need to include the IODF device address along with the parameter: > > eg. > LOADPARM 0380pppp > > or > LOADPARM 0A82pppp > > > I tried putting just LOADPARM CS in my hercules.cnf (instead of > 0A95CS..) and got a disabled wait state 'B3' > > On 5/25/19, gheorghedragos1988-/[email protected] [hercules-390] > <[email protected]> wrote: >> Michael, >> >> I will try. However, just to eliminate all possibilities, I have >> performed >> ipl saying that the sys res is on SARES1. It throws a completely >> different >> error. When I used a made up loadparm it shows a completely different >> error. >> When I use correct load parm and sys res it throws 31. >> >> Play this one ... >