Re: Re: RHEL 7.x installation

"Ivan Warren [email protected] [hercules-390]" <[email protected]>
Newsgroups gmane.comp.emulators.hercules390.general
Message-ID <[email protected]>
You may need to enable some facility flags (even if the facility is not 
implemented)

Try adding the following to your hercules config file :

   ARCHLVL   ENABLE BIT44

--Ivan

Le 6/11/2019 à 5:30 PM, [email protected] [hercules-390] a écrit :
>
>
> Well that did not take very long. I tried RH 6.5 and the install 
> immediately failed with
>
> HHC00811I Processor CP00: architecture mode z/Arch
> HHC02204I CPUSERIAL      set to 000611
> HHC02204I CPUMODEL       set to 3090               & nbsp;
> HHC17003I MAIN     storage is 2G (mainsize); storage is not locked
> HHC17003I EXPANDED storage is 0 (xpndsize); storage is not locked
> HHC01441E Config file[10] conf/linux.conf: error processing statement: 
> HTTPPORT 8081
> HHC00007I Previous message from function 'process_config' at 
> script.c(431)    & nbsp;
> HHC02204I NUMCPU         set to 1
> HHC02204I LOADPARM       set to 0120....
> HHC02204I TODDRAG        set to 1&nbs p;
> HHC02204I ARCHLVL        set to z/Arch
> HHC02204I PANRATE        set to FAST                          & nbsp;
> HHC00414I 0:0120 CKD file /usr4/hercules/rh6.5_390x/dasd/linux.120: 
> model 3390-9 cyls 10017 he
> HHC00414I 0:0121 CKD file /usr4/hercules/rh6.5_390x/dasd/linux.121: 
> model 3390-9 cyls 10017 he
> HHC00414I 0:0122 CKD file /usr4/hercules/rh6.5_390x/dasd/linux.122: 
> model 3390-9 cyls 10017 he
> HHC00901I 0:0E20 LCS: Interface tap0, type TAP opened
> HHC00921I CTC: lcs device port 00: manual Multicast assist 
> enabled                          ;
> HHC00935I CTC: lcs device port 00: manual Checksum Offload enabled
> HHC01603I ipl 000c
> HHC00811I Processor CP00: architecture mode ESA/390
> The Linux kernel requires more recent processor hardware
> HHC00809I Processor CP00: disabled wait state 000A0000 8BADCCCC
>
> I did notice that CP00 originally shows architecture mode z/Arch but 
> right after the IPL, it shows ESA/390? Not sure why rh6.5 fails with 
> this but rh6.10 does not (although those fail the post-installation ipl).
>
>
>
> 


[Non-text portions of this message have been removed]
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.