Re: Re: quit files

But Hercules *IS* ending correctly according to the quit command. I posted
the *ENTIRE* 3033.log as well as the hardcpy.log.

When I type "quit" at the Hercules command prompt *AFTER* I shut down MVS,
I get a clean shut down every time.

I also use the same Hercules to run OS/390 ... with no problems.

Clearly it is a procedural error and not a software error.

Joe

On Sat, Jun 22, 2019 at 2:53 PM [email protected] [hercules-390] <
[email protected]> wrote:

>
>
> Hi Paul
>
> Then, please, provide a complete error report describing a reproducible
> scenario.
>
> Please note that TK4- Hercules is frozen, as it will be replaced by SDL
> Hyperion shortly. So, problem reports against TK4- Hercules will no longer
> be accepted. If the problem occurs in a TK4- environment only, it must be
> reproducable on SDL Hyperion 4.2.0.9576 or later.
>
> Cheers
> Jürgen
>
> ---In [email protected], <kerravon86@...> wrote :
>
> ---In [email protected], <winkelmann@...> wrote :
>
> > you simply don't want to understand: The log file
> > doesn't get truncated. It simply _is_ incomplete
> > because Hercules didn't end gracefully.
>
> That is exactly my problem report - Hercules
> isn't ending gracefully in response to the
> "quit" command. It doesn't even write out
> its own log file properly. If no-one wants to
> fix it, that's fine. But it is a valid problem report.
> Yes, it can be worked around by having fewer
> devices or whatever. I don't experience the
> problem with tk3upd which is why I'm only
> reporting it now.
>
> BFN. Paul.
>
> 
>