RE: Re: Full screen application Specs

That should be the logic ecept for the PF7 and PF8 - I'll have to look
closer at what happens.
I brok a coule of my own rules here and leave some subroutines via Branch
instead of L  14,xxx -  bcr 15,14
 
action (line commnads have preference.)  CC does nothing yet. but it has
preference. and the top bottom on a separate transaction.
 

I just fixed the Upper case problem but I ran out of BASE registers - So
tommrow will be devoted to reorganizing into subroutines under separate base
registers. and that means that I have to get rid of those shortcuts of
leaving subroutines with a BR instead of a  load and BCR 
 
A I said  "PRE PRE PRE ALPHA"
 
Needed to do get the code clean any way. - Better now than later.
 
But it is definitely more than a simple tool for editing ten line scripts.
 
ROC



  _____  

From: [email protected] [mailto:[email protected]] On Behalf Of
Fran Hensler
Sent: Monday, July 26, 2010 21:08 
To: [email protected]
Subject: Re: [H390-VM] Re: Full screen application Specs


  

Rocky -

I just tried the editor. Just for fun I entered CC on two lines in the
prefix area. Then TOP and BOT commands did nothing even when I removed
the CC from both places. But th PF7 and PF8 were still working.

I did add lines and delete lines with not trouble.

BTW, I would prefer to stick to Xedit standards where possible. So CC
should be followed by P or F, not A or B.

I am amazed at how far you have come in such a short time. Keep up the
good work -- it is much appreciated.

/Fran Hensler at Slippery Rock University of Pennsylvania USA for 47 years
mailto:[email protected] <mailto:fjh%40zvm.sru.edu>  http://zvm.sru.edu/~fjh
+1.724.738.2153
"Yes, Virginia, there is a Slippery Rock"
----------------------------------------------------------