Re: creating DASD
Mike Ward <[email protected]>
| Newsgroups | gmane.comp.emulators.hercules390.vm |
|---|---|
| Message-ID | <[email protected]> |
If I remember correctly a special device like a 3270 you could dial to. A dedicated device was a real device and was dedicated(attached) to that VM. --- On Sat, 8/7/10, Mike Stramba <[email protected]> wrote: From: Mike Stramba <[email protected]> Subject: Re: [H390-VM] creating DASD To: [email protected] Date: Saturday, August 7, 2010, 2:57 PM What's the difference between "dedicated" and "special " ? On 8/7/10, Mike Ward <[email protected]> wrote: > You can dedicate the console in the vmdir. Then when you logon the console > is at address whatever you dedicated it as maybe at 010. Then you ipl or if > you autolog it the ipl command can be set in the vmdir. It's really very > simple, but normally you don't run a paging system under a paging system. > VSE, or DOS/VS, or VS1 are good candidates to run under VM. That's not to > say you can't do other operating systems. > > --- On Sat, 8/7/10, Ivan Warren <[email protected]> wrote: > > From: Ivan Warren <[email protected]> > Subject: Re: [H390-VM] creating DASD > To: [email protected] > Date: Saturday, August 7, 2010, 3:46 AM > > Dave Wade wrote: >> >>> It has to be connected before IPL, but before MVS is IPL'd, what does >>> a 3270 connect to ? .. kind of a "chicken and the egg' / catch 22 ? >>> >> >> I don't recall the details, but as IPL drops dialed devices it can be >> tricky. Try searching the message archive.... >> > > CP IPL <CUU> STOP > .. Do the Dial > CP BEGIN > > --Ivan >