Re: Re: Sixpack 1.2: how to log in two users?
Mike Voss <[email protected]>
| Newsgroups | gmane.comp.emulators.hercules390.vm |
|---|---|
| Message-ID | <[email protected]> |
@Mike S: >VM manuals here : >http://bitsavers.org/pdf/ibm/370/vm370/ Thanks, that was spot-on what I needed... --- On Wed, 8/11/10, Mike Stramba <[email protected]> wrote: From: Mike Stramba <[email protected]> Subject: Re: [H390-VM] Re: Sixpack 1.2: how to log in two users? To: [email protected] Date: Wednesday, August 11, 2010, 1:51 AM Mike, VM manuals here : http://bitsavers.org/pdf/ibm/370/vm370/ Look in the sysgen / sys programmer manuals for the segment stuff IO is in DMKRIO ASSEMBLE (B or F) disk I'm hazy on how it all works, I'm a noob too. On 8/11/10, paoloG <[email protected]> wrote: > > > --- In [email protected], Mike Voss <mike@...> wrote: >> >> Now for an *actual* noob question: >> >> terminals 0C0-0C2 are defined in hercules, but I can only open a session >> and connect to CP through 0C0. 0C1 just sits at the Hercules banner. >> >> I've heard the term directory, how does that interact with or substitute >> for VM's IOGEN? Where do I find either of these entities? -Or does this >> have nothing at all to do with that? >> >> A two-or-three-sentence primer on VM I/O targeted to an MVSer will >> probably kickstart me suitably. I know MVS sysgens but this seems to come >> at me a little bit sideways. I'll wager that at the end of the day it's >> more familiar than I think. >> I always secretly wanted to be a DOS/VM guy but none of my employers ever >> wanted to, er, "re-size" their existing MVS installation. At my very first >> shop we were bringing the systems in-house from a service bureau, and all >> the VM manuals had arrived, and I was burning through those when they >> changed their minds and I had to learn instead to support MVS/SP. Can't >> complain, it just would have been fun... -and retrospectively, the right >> call for a company of that size. IBM sales was just too darn good. >> > > I've the same issue with C1 terminal; it starts disabled. > So you have to give 'ENA C1' or 'ENA ALL' command from VM OPERATOR console > (if you are using HercGui give /ENA C1 on the command line. > Believe it's a sort of bug in SixPack. > > Regards > > Paul > > > > ------------------------------------ > > Yahoo! Groups Links > > > >