Re: z/VM 6.1 under Hercules - How To

All,

Just out of curiosity, I wonder how difficult (not being familiar with the STFLE code in Hercules) it would be to have a different OSTAILOR option that told the STFLE instruction 'hey, this is z/vm', and thus amended the response proffered by Hercules so this kind of customized trace and remediation procedure per Z/VM version would be rendered moot.


Blake


--- In [email protected], Harold Grovesteen <h.grovsteen@...> wrote:
>
> Can you explain what you are changing and why?  I suspect it is STFLE 
> bits, but am curious. 
> 
> Harold Grovesteen
> 
> ioob@... wrote:
> 
> >To All,
> >    For the group. Basically you have to set a Breakpoint in Hercules, modify VM storage and continue the IPL. I strongly suggest you use the Hercules CMD Prompt window, not the Hercules GUI. If you're using the z/VM 6.1 Base system, follow/use the "Base" values below. If you apply the z/VM 6.1 RSU, then use the values on the left side.
> > 
> >Once a new RSU comes out, it may modify storage locations again and a new Hercules Trace will have to be done (see below).
> >
> >IPL (from Hercules CMD prompt window)
> >
> >1. hercules -f c:\hercules\zvm610\hercules.txt            (change to your Hercules config file location)
> >2. B+ 2AAF98                                  (z/VM 6.1.0 Base: 2AA998)
> >3. IPLC 340D                                   (replace address with your IPL address)
> >4. GPR                                              (R2=002F4108) (z/VM 6.1.0 Base: R2=002F3008)
> >5. R 2F4108                                      (z/VM 6.1.0 Base: R 2F3008 ---> xxxxxxxx F0700000)
> >6. R 2F410C=F0FF0000                   (z/VM 6.1.0 Base: R 2F300C=F0FF0000)
> >7. (press ENTER)
> >   (IPL should complete normally)
> >8. CMDTGT SCP                              (sends commands to z/VM)
> >8.5 ENABLE ALL                              (enable all VM 3270 terminals)
> >...have fun...
> >9. HERC CMDTGT HERC                (sends commands back to Hercules)
> >10. QUIT                                          (exit hercules)
> >
> >Hercules TRACE (took approx. 40 mins on my 2.53Ghz laptop)
> >1.Log c:\herclog.txt
> >2.traceopt noregs
> >3.T+
> >4.IPLC 340D
> >6.G
> >
> >
> >
> >------------------------------------
> >
> >Yahoo! Groups Links
> >
> >
> >
> >
> >  
> >
>