Re: Question about lp5250d and SCS2ASCII
"Alberto" <a.ernestini-UVFfO7pX/[email protected]>
| Newsgroups | gmane.comp.emulators.tn5250 |
|---|---|
| Organization | midrange.com |
| Message-ID | <[email protected]> |
Hi Again, i've made the scs dump as suggested. Building it i've discovered that the file get splitted only if i use the HPT, so using a standard printer with NO HPT will output only one file. But setting it to ex: *LEXOPTRAC make the emulator split the output file(means that scs2ascii will not be part of the problem?). I've them ready ( cleaned of some private data for our privacy), but where i have to send them? Thanks. Ciao. Alberto. "James Rich" <[email protected]> ha scritto nel messaggio news:mailman.27892.1273787583.2580.linux5250-Zwy7GipZuJitq2lpoERdew@public.gmane.org > On Thu, 13 May 2010, Scott Klement wrote: > >> To me, the problem seems to be in the way lp5250d reads the SCS stream. >> He says it's chopping the data into multiple files when it shouldn't >> -- and that would imply that it's happening when the SCS is generated, >> not when scs2ascii processes the output. >> >> So I'm not sure dumping the raw SCS to disk would help much? > > That could be. But a raw dump would definitely point to either lp5250d or > scs2*. Maybe not useful other than definitively answering that point. > > James Rich > > if you want to understand why that is, there are many good books on > the design of operating systems. please pass them along to redmond > when you're done reading them :) > - Paul Davis on ardour-dev -- This is the Linux 5250 Development Project (LINUX5250) mailing list To post a message email: LINUX5250-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/linux5250 or email: LINUX5250-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/linux5250.