Re: Problem with TN5250

Which front-end to TN5250 are you using?  Curses? Slang? xt5250? x5250? 
gtk-5250?

This "error" is obviously an issue that you don't know where the "error 
reset" key is on your keyboard, but I can't assist unless I understand 
your environment.


On 6/10/2011 11:01 AM, John Aldrich wrote:
> Trying to use TN5250 here on a Debian box. It works fine until we get an
> error message and then it locks up the whole session and we have to close
> the window and restart it. Unfortunately that is a non-starter.
>
> This is not a "critical" error... just a warning, in this case, it's telling
> us that we haven't entered any roll numbers for the carpet and we should
> enter some roll numbers... but we can't get that far because it's blocking
> us. On the official Windows 5250 client, we just hit "ctl" and it goes away
> and we can proceed. However, that doesn't work for us with TN5250.

-- 
This is the Linux 5250 Development Project (LINUX5250) mailing list
To post a message email: LINUX5250-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/linux5250
or email: LINUX5250-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/linux5250.