Re: IEF488I IPLASM - SYSPUNCH MUST WAIT FOR UNIT 00D

> I'm trying to run an assemble job, output to punch, but get :
> 
>  IEF488I IPLASM - SYSPUNCH MUST WAIT FOR UNIT 00D
> *02 IEF238D IPLASM - REPLY 'WAIT' OR 'CANCEL'.
> 
> (I didn't reply to 02 with 'WAIT' either, is that the turnkey "autopilot" ?)
> 
>  $HASP100 IPLASM   ON INTRDR
>  $HASP373 IPLASM   STARTED - INIT  1 - CLASS A - SYS BSP1
>  IEF403I IPLASM - STARTED - TIME=01.31.23
>  IEF244I IPLASM STEP01 - UNABLE TO ALLOCATE 1 UNIT(S)
> T LEAST 1 ALLOCATED UNIT(S) NEEDED.
> 
>  IEF488I IPLASM - SYSPUNCH MUST WAIT FOR UNIT 00D
> *02 IEF238D IPLASM - REPLY 'WAIT' OR 'CANCEL'.
> 
>  IEE600I REPLY TO 02 IS;'WAIT'
> *03 IEF433D IPLASM - WAIT REQUESTED -- REPLY 'HOLD' OR 'NOHOLD'.
>  IEE600I REPLY TO 03 IS;'NOHOLD'

It's probably allocated to JES2.  Do a $ppun1 to drain
the punch.

--