Re: Re: IEF488I IPLASM - SYSPUNCH MUST WAIT FOR UNIT 00D

Jay Maynard <jmaynard-NaA3cy51gWZWk0Htik3J/[email protected]>
Newsgroups gmane.comp.emulators.turnkey-mvs
Message-ID <[email protected]> 
On Sat, Mar 27, 2010 at 12:08:47AM -0000, Kevin Leonard wrote:
> > I'm trying to run an assemble job, output to punch, but get :
> It's probably allocated to JES2.  Do a $ppun1 to drain
> the punch.

Yes.

With that said...Is there a reason you're allocating the punch directly
instead of simply writing to SYSOUT=B?
-- 
Jay Maynard, K5ZC                   http://www.conmicro.com
http://jmaynard.livejournal.com      http://www.tronguy.net
http://www.hercules-390.org               (Yes, that's me!)
Buy Hercules stuff at http://www.cafepress.com/hercules-390
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.