Re: IEF488I IPLASM - SYSPUNCH MUST WAIT FOR UNIT 00D

Kevin,

Ok, that worked .. sort of.   I do get the output going to the punch now.


I'm trying to generate IPL text, when I feed that output to the Hercules dasdload command, I get :

HHCDL036E IPL000.TXT is not a valid object file

The same jcl (except I changed IFOX00 to IEUASM) did generate an IPL'able / "dasdload friendly" deck from MVT.

And MVT didn't complain about the punch being unavailable.

What is special about the punch vs the printer, or reader for JES2?

Mike



> It's probably allocated to JES2.  Do a $ppun1 to drain
> the punch.


--- In [email protected], "Kevin Leonard" <kl_j76@...> wrote:
>
> > I'm trying to run an assemble job, output to punch, but get :
> > 
> >  IEF488I IPLASM - SYSPUNCH MUST WAIT FOR UNIT 00D
> > *02 IEF238D IPLASM - REPLY 'WAIT' OR 'CANCEL'.
> > 
> > (I didn't reply to 02 with 'WAIT' either, is that the turnkey "autopilot" ?)
> > 
> >  $HASP100 IPLASM   ON INTRDR
> >  $HASP373 IPLASM   STARTED - INIT  1 - CLASS A - SYS BSP1
> >  IEF403I IPLASM - STARTED - TIME=01.31.23
> >  IEF244I IPLASM STEP01 - UNABLE TO ALLOCATE 1 UNIT(S)
> > T LEAST 1 ALLOCATED UNIT(S) NEEDED.
> > 
> >  IEF488I IPLASM - SYSPUNCH MUST WAIT FOR UNIT 00D
> > *02 IEF238D IPLASM - REPLY 'WAIT' OR 'CANCEL'.
> > 
> >  IEE600I REPLY TO 02 IS;'WAIT'
> > *03 IEF433D IPLASM - WAIT REQUESTED -- REPLY 'HOLD' OR 'NOHOLD'.
> >  IEE600I REPLY TO 03 IS;'NOHOLD'
> 
> It's probably allocated to JES2.  Do a $ppun1 to drain
> the punch.
> 
> --
>