Re: Re: RPF - INPUT CONVERT FAILED

On Wed, May 12, 2010 at 7:51 AM, Ron Hudson <[email protected]> wrote:

>
>
> On Wed, May 12, 2010 at 7:35 AM, dadkool <[email protected]> wrote:
>
>>
>>
>>
>>
>> --- In [email protected] <turnkey-mvs%40yahoogroups.com>, Ron
>> Hudson <hudson.ra@...> wrote:
>> >
>> > Hey DadKool,
>> >
>> > I went and looked at the RPF user's guide and found "Input Convert
>> Failed"
>> > but it looks
>> > like it only comes out when one makes some entry on the command area
>> (not
>> > the
>> > number area or the text area the one line up near the top) when the
>> editor
>> > is expecting
>> > "END" or "RETRY". Did the next message mention "End" & "Retry" ?
>> >
>> >
>> > (RPF user's guide page 33)
>> >
>> > Ron.
>> >
>> > On Tue, May 11, 2010 at 7:32 PM, dadkool <kool6@...> wrote:
>> >
>> > >
>> > >
>> > > I'm trying to edit "ADDUSER". When I change the HLQ=USERID and hit
>> enter I
>> > > get the message "INPUT CONVERT FAILED". The RPF manual doesn't explain
>> why
>> > > this message occurs. Can anyone tell me what the problem is?
>> > > Thanks.
>> > >
>> > >
>> > >
>> >
>>
>> Ron,
>>
>> Yes I did. When I enter "END", RPF leaves edit mode. When I edit the job
>> again, my change does not show up.
>>
>
> Try entering "SAVE" there.
>
> Hmm, You probably had typed SAVE, then got that message and then then
> RPF was expecting END (to stop trying to save) or REPLY (to attempt to save
> again)
>
> Guessing big here.
>
> If this is so we will have to escalate the problem to someone who knows
> more than I do
> because RPF is having some problem writing the file. I think.
>
> Are you logged on as a user with authority to do this?  (HERC01 HERC02
> IBMUSER or
> a user you added with ACCT set)
>

OH wait - your just editing the file, not actually running it just yet -
forget that about
being logged on as an authoritative user... sorry.

Ron again.


>
>
>  Ron.
>
>
>
>>  
>>
>
>