Re: r 00, clpa and subsequent "Invalid Reply Format"

Anyanso,

On Fri, May 14, 2010 at 02:30:30AM -0000, Anyanso wrote:

> In my 3270 terminal, I put the command: r 00,clpa ; and the terminal
> display: IEA212A DUPLICATE VOLUME 'SPOOL0' D, 150 OR 151. REPLY DEVICE
> ADDR

This early in the IPL process one has to use the "old style" reply format.
And, this early no message IDs are displayed, so the ID used to reply to the
message is 00.  Try:

r 00,150

> Do you have any idea what is the problem?

You have two DASD volumes at addresses 150 and 151 with the same VOLSER -
SPOOL0.

> And what must I do with the duplicate Volume issue?

IEA212A is asking which volume should be dismounted.  Reply with the address
of the volume to dismount.
 
> Both volumes seem to have data. There are of SPOOL variety but with
> different device address:
>  
> 0150 3330 c:/PROGRA~1/mvs38j/dasd/spool0.150  size=62 KB
> 0151 3330 c:/PROGRA~1/mvs38j/dasd/spool0.151  size=2.46 MB

I checked my Turnkey setup and I also have a spool0.150 DASD file of the
same size.  It's not referenced in any of the config files that came with my
copy of the Turnkey.  Since it has the same VOLSER as spool0.151 I suspect
it was included unintentionally.  It's small size suggests that there's
nothing on it.  The config file I've been using has the starter system
SYSRES volume, dasd/start1.150, at address 150.  


-- 

Kevin
http://www.RawFedDogs.net
http://www.WacoAgilityGroup.org
Bruceville, TX

What's the definition of a legacy system?  One that works! 
Errare humanum est, ignoscere caninum.