Re: r 00, clpa and subsequent "Invalid Reply Format"

--- In [email protected], "Anyanso" <pagwu@...> wrote:
>

Anyanso, you previously said that you had installed
here:

\hercules\mvs38j\dasd\

I see that you have now got an installation in a
different directory:

> 0150 3330 c:/PROGRA~1/mvs38j/dasd/spool0.150  size=62 KB
> 0151 3330 c:/PROGRA~1/mvs38j/dasd/spool0.151  size=2.46 MB

Therefore you have done an install by a different
method, without mentioning that fact. If you
aren't installing via the documented method, but
instead using a "helper" script, then you need to
let everyone know, so that the right support
people will deal.

I'm pretty sure the helper script did not put the
above in the config file. You presumably changed
it yourself. That change is wrong, and causing
you your current problem. Why did you change it
in the first place? Was there some other problem?

Regardless, you need to put it back to how it was,
which in your case should be:

> 0150 3330 c:/PROGRA~1/mvs38j/dasd/start1.150

What else have you changed? I've looked at the
turnkey_mvs.conf and I can't see anything that
you SHOULD be changing. If you change things
without letting anyone know, it makes it very
difficult to figure out what the problem is.

If you start with one problem at a time, there's
more chance of a successful install.

I know it's difficult when 5 people give different
suggestions - but you need to say which one you
decided to choose, as they are usually different
paths to the same end result.

BFN.  Paul.