Re: Cannot setup >1 cipe interfaces
"Renato Salles" <[email protected]>
| Newsgroups | gmane.comp.encryption.cipe |
|---|---|
| Message-ID | <[email protected]> |
[email protected] disse: > hi, > > i try to setup cipe for more than one roadwarrior. > i tested with one cipe tunnel and it worked, > now i try to setup a second cipe interface on redhat server, > so i copied the options.cipcb0 file to options.cipcb1 and altered the > settings in the new options.cipcb1 file. > when i start the ciped service it tries to start the cipcb1 and the the > cipcb0, > but cipcb0 fails with error in log: > > ciped-cb[xxxxx]: opendev: bind: Address already in use > > > can someone tell me what i am doing wrong? > > regards, wolf Don't you have a parameter like that in both interfaces: ME=0.0.0.0=1.2.3.4 Where 1.2.3.4 is the IP address of the TUNNELDEV interface? If so, 0.0.0.0 stays as any/all ip addresses, and this address could be in use by the "other" CIPE interface. Solution: perhaps a "virtual" interface, pointing to the TUNNELDEV previously marked. Best Regards, RSalles -- Renato Salles Ger.Geral RSNetServices -- Message sent by the [email protected] mailing list. Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body Other commands available with "help" in body to the same address. CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>