RES: Cannot setup >1 cipe interfaces

or the same interface for cipcb1
in ifcfg-cipcb1
DEVICE=cipcb0
 
check options.cipcb1
 
 
 
-----Mensagem original-----
De: [email protected] [mailto:[email protected]] Em nome de Russell
Berry
Enviada em: terça-feira, 16 de setembro de 2003 12:58
Para: [email protected]; [email protected]
Assunto: Re: Cannot setup >1 cipe interfaces


You need to include your cipcb0 and cipcb1 files with keys commented out and
routeable IP addressess replaced with xxx.xxx.xxx.xxx for your own
protection.
 
My guess is you're using the same udp port numbers for both interfaces...
But it could be something else, can't know without seeing the configs.
 
Regards,
---russ
 
 

Russell Berry
Berrex Computer Solutions
http://www.berrex.com
[email protected]
1-877-558-9507

----- Original Message ----- 
From: [email protected] 
To: [email protected] 
Sent: Tuesday, September 16, 2003 11:40 AM
Subject: Cannot setup >1 cipe interfaces


hi, 

i try to setup cipe for more than one roadwarrior. 
i tested with one cipe tunnel and it worked, 
now i try to setup a second cipe interface on redhat server, 
so i copied the options.cipcb0 file to options.cipcb1 and altered the 
settings in the new options.cipcb1 file. 
when i start the ciped service it tries to start the cipcb1 and the the
cipcb0, 
but cipcb0 fails with error in log: 

ciped-cb[xxxxx]: opendev: bind: Address already in use 


can someone tell me what i am doing wrong? 

regards, wolf