RE: cipe-win32 service fails to start

Ahh. Since this is th easiest thing to change, and change back, I will do
this first. I have dns setup for another address on the same subnet, and I
have changed the Local-IP Address setting in Cipe CPL box. Just on change,
does not start the service. I am rebooting as I write this......It seems
that this makes no difference. I get the same messages. I will reboot once
more with the service on manual. I think Stuart is onto something. I will
try his suggestion next. The service still does not start afterthe last
reboot.

Thanks
-Rob

On Wed, 10 Dec 2003, Mark Smith wrote:

> That would explain it - linux allows you to bind to a non-existant address
> and forces it to be valid.  The Win32 version does not.  The local IP
> address must be on one of the local subnets for the machine, preferably the
> one on which the outbound packets will leave and inbound packets will
> arrive, even if this is a private address that is never seen by the other
> end.  Your config, if I read it correctly, would use 192.168.5.3 or more
> likely another address on this subnet.  The address you specify is
> deliberately not sent in any packets, so the other end will still see the
> external IP address correctly.
>
> Hope this helps,
>
> --
> Mark Smith - Avco Systems Ltd
> email: [email protected]
> Tel: +44 (0)1784 430996 Fax: +44 (0)1784 431078
>
>
> --
> Message sent by the [email protected] mailing list.
> Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
> Other commands available with "help" in body to the same address.
> CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>
>



--
Message sent by the [email protected] mailing list.
Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
Other commands available with "help" in body to the same address.
CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>